13 Finishing
A. Framing and Finishing Instructions
WARNING! Risk of Fire! Comply with all minimum clear- ances to combustibles as specified. Framing closer than the minimums listed must be constructed entirely of noncom- bustible materials (i.e., steel studs, concrete board, etc.)
Finishing Instructions
It is important to follow the framing and finishing instruc- tions to ensure proper placement of fireplace into the sur- rounding framing/finishing materials.
Wall sheathing materials 3/8 in. (10 mm) thick are specified in this installation manual to properly align with the
WARNING! Risk of Fire! DO NOT remove the factory- installed
•Drywall (gypsum board)
•Plywood
•Materials that do not meet the ASTM E 136
Removal of
Non-Combustible Materials Specification
Material which will not ignite and burn. Such materials are those consisting entirely of steel, iron, brick, tile, concrete, slate, glass or plasters, or any combination thereof.
Materials that are reported as passing ASTM E 136,
Standard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750 ºC and UL763 shall be considered
Setting the Fireplace into the Framing
Unlike many traditional,
1.Bend two nailing tabs away from fireplace 180 degrees on both left and right nailing tabs. Do not adjust the column standoffs. See Figure 13.1.
2.Screw each nailing tab to the adjoining framing material. Ensure that the air space clearance is maintained on the sides of the fireplace. See Figure 13.2.
FINISH WALL MATERIAL MAY BE
COMBUSTIBLE - TOP AND SIDES
8 in. | |
203 mm | 0 mm |
| 29 in. |
| 740 mm |
0 mm | 0 mm |
SEALANT MATERIAL
Figure 13.1 Noncombustible Facing Diagram
B. Mantel Projections
No mantels are allowed when using
Note: All dimensions are shown in millimeters
|
|
| 305 |
|
|
| 279 |
|
|
| 254 |
|
| 229 |
|
| 203 |
| 381 |
| 178 |
| 356 |
| 152 |
| 330 |
| 127 |
| 305 |
| 102 | 279 | 407 |
|
| ||
76 | 254 |
|
|
51 | 229 |
|
|
26 | 203 |
|
|
| 178 |
|
|
| 152 |
|
|
127 |
|
|
|
OPENING OF FIREPLACE
Figure 13.2 Minimum vertical and maximum horizontal dimensions of combustibles above appliance when using the
Heat & Glo • | 57 |