Heat & Glo LifeStyle 6000TRS-CD manual Getting Started, Introducing the Heat & Glo Gas Fireplaces

2

Getting

Started

8

Introducing the

Heat & Glo

Gas Fireplaces

Pre-installation Preparation

Heat & Glo direct flue gas fireplaces are designed to operate with all combustion air siphoned from outside of the building and all exhaust gases expelled to the outside.

The information contained in this Installers Guide, unless noted otherwise, applies to all models and gas control systems.

Gas fireplace diagrams, including the dimensions, are shown in this section.

This gas fireplace and its components are tested and safe when installed in accordance with this Installers Guide. Report to your dealer any parts damaged in shipment, particularly the condition of the glass. Do not install any unit with damaged, incomplete, or substitute parts.

The flue system components and trim doors are shipped in separate packages. The gas logs are packaged separately and must be field installed.

Read all of the instructions before starting the installation. Follow these instructions carefully during the installation to ensure maximum safety and benefit. Failure to follow these instructions will void the owner’s warranty and may present a fire hazard.

The Heat & Glo Fireplace Products, Inc. Warranty will be voided by, and Heat & Glo Fireplace Products, Inc. disclaims any responsibility for, the following actions:

•Installation of any damaged fireplace or flue system component.

•Modification of the fireplace or direct flue system.

•Installation other than as instructed by Heat & Glo Fireplace Products, Inc.

•Improper positioning of the gas logs or the glass door.

•Installation and/or use of any component part not manufactured and approved by Heat & Glo Fire- place Products, Inc., not withstanding any indepen- dent testing laboratory or other party approval of such component part or accessory.

ANY SUCH ACTION MAY POSSIBLY CAUSE A FIRE HAZARD.