Heat & Glo LifeStyle 6000TRS-CD manual B. Installing Flue Components, Venting Out the Rear Flue

B. Installing Flue Components

After determining which set of starting collars will be used (top or rear), follow venting instructions accordingly.

Venting Out the Rear Flue

Remove the installed rear seal cap from the rear starting collars by cutting the strap at each end (See Figure 15). Follow the flue configuration tables accordingly.

Remove the 12.7cm diameter heat shield from the 1.27cm diameter collar by sliding it out. Remove insulation piece.

WARNING: THE TOP HEAT SHIELD (INSIDE

!THE FIREBOX) MUST REMAIN ATTACHED IF THE FLUE SYSTEM IS ATTACHED TO THE REAR STARTING COLLARS. SEE FIGURE 15.

Venting Out the Top Flue

Remove the top flue collar seal cap by cutting the strap on each end. Remove both pieces of insulation inside the top two starting collars (see Figure 15).

Remove the 10.2cm diameter heat shield from the 10.2cm diameter collar by sliding it out.

You have to take the glass off again for positioning the logs when the unit is finally installed in place and finished around it. Reinstall the glass door. Attach flue system to the top starting collars.

WARNING: THE REAR FLUE COLLAR SEAL

!CAP MUST REMAIN ATTACHED TO THE REAR FLUE COLLARS IF THE FLUE SYSTEM IS ATTACHED TO THE TOP STARTING COL- LARS. SEE FIGURE 15.

!WARNING: FAILURE TO REMOVE INSULA- TION IN THE SET OF COLLARS YOU ARE USING COULD CAUSE A FIRE.

!WARNING: YOU MUST LEAVE THE INSULA- TION IN PLACE IN THE SET OF COLLARS YOU ARE NOT USING.

20

Insert screwdriver		Venting
or similar object	Out Rear
here to remove cap.

HEAT

SHIELD

DISCARD

INSULATION

CUT HERE

		Venting
		Out Top
SEAL	SEAL	INSULATION,
	CAP	DISCARD
CAP
		BOTH
		PIECES
		HEAT
	SHIELD

Figure 15