Heat & Glo LifeStyle 6000CL-IPI-S Appliance Setup, A. Remove Fixed Glass Assembly, D. Accessories

14 Appliance Setup

A. Remove Fixed Glass Assembly

See Section 14.I.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

E. Burner Top Installation 

1.Bend the two tabs upward as shown in Figure 14.1.

2.To install the fiber burner, mate the locating holes with the guide sleeves. Install fiber burner top so that it makes full contact with the underlying burner assem- bly.

3.Ensure that the ports in the steel burner are visible through the holes in the fiber burner top.

FIBER BURNER TOP	LOCATING HOLES
BEND TABS UP
		AIR SCOOP
BURNER ASSEMBLY		PILOT COVER
		BURNER SHIELD
GUIDE SLEEVES

Figure 14.1

58

Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. S • 9/12