Heat & Glo LifeStyle 8000CL-IPI-S 1 23 4, Right Grate Tine, Horizontal Grate Bar, Flat Area

RIGHT GRATE TINE

1

23

HORIZONTAL GRATE BAR

1

23

4

Figure 7

Figure 8

LOG #4 CONTACTS LOG #2

Log #3 (SRV2168-703): Mate the slot located on the bottom of Log #3 with the right log placement tab on top of Log #1. After slot and tab have been fitted together, mate the groove located on the bottom of Log #3 with the horizontal grate bar and far right grate tine. Log #3 will sit down on top of both the grate tine and the horizontal grate bar (see Figure 7.)

Log #4 (SRV2168-704): Place Log #4 in the left log indentation on the burner top (see Figure 2). Slide Log # 4 from right to left under Log #2 to fit completely and securely into the indentation (see Figure 8). The back or Log # 4 should rest against the far left grate tine as well as contact Log # 2.

FLAT AREA 1

23

LOG #6 CONTACTS TOP OFLOG #4

		FLAT AREA
	1	LOCATING
2		NOTCH

4

Figure 9

5

4 6 5 3

Figure 10 LOG CONTACTS GRATE TINES

Log #5 (SRV2168-705): Place Log #5 in the right log indentation on the burner top (see Figure 2). Ensure the log fits completely and securely in the indentation (see Figure 9). Log #5 should be pulled to the left hand side of log indentation.

Log #6 (SRV2168-706): Mate the groove located on the lower end of Log #6 with the fourth tine (from left to right) as shown in Figure 10. Set the other end of Log #6 on the flat area located on top of Log #4 (see Figure 9). Log #6 will also rest against center grate tine. When properly installed, Log #6 will rest securely on all 3 contact points, not allowing movement or shifting.

RAISED KNOT

2	1		3
4	6	5	7

Figure 11

Log #7 (SRV2165-707): Place back (unnotched) end of Log #7 on the flat area on the top of Log #5. Log #7 must be pulled tight to the locating notch. Pivot the front (notched) end of Log #7 to the right until the notch of Log #7 contacts the grate tine located 4th from the left as shown in Figure 11.

2169-935B

64

Heat & Glo • 6000CL-IPI-S, 6000CL-IPI-T, 8000CL-IPI-S 8000CL-IPI-T • 2165-900 Rev. S • 9/12