Heatcraft Refrigeration Products PRO3 manual Installation Method #2, 29.00, 20.07, 23.00

PRO3 Side Mount Packaged Refrigeration System

Installation Method #2	Figure 7: Plug Detail
Side Installation (See FIGURES 7, 8, and 9)
This installation method is intended for applications that have
height restrictions that do not allow the unit to be installed from
above (see method #1) and installations into pre-existing boxes
where it is impractical to remove the roof.
In order to install a unit using this method, you must provide an	SEE PLUG DETAIL
additional “plug” section of the box to fill in the open space between
evaporator arms after installation. This section should contain cam
locks to anchor it in place.

Please use the following guidelines when completing the installation in this manner.

1.Provide a finished opening with the appropriate dimensions from Figure 8 or 9.

2.The cut-out section should not be placed in a location where it would degrade the structural integrity of the box (should not interfere with cam locks)

3.The unit will need to be lifted to the appropriate height and inserted into the open slot. The bottom of the unit should be temporarily supported during the remainder of the installation process (no portion of the unit should be supported by the bottom of the evaporator section as this WILL cause damage to the drain pan).

4.You should use cam locks to re-connect the “plug” section after installing the unit, firmly attach the unit to the box and carefully seal all seams.

Figure 8: Plug Detail Small Cabinet	Figure 9: Plug Detail Large Cabinet
23.00	29.00

20.00

CAMLOCKS	20.07
4 PLACES

CAMLOCKS 4 PLACES

PRO3 Side Mount Packaged Refrigeration System Installation and Operations Manual, May 2008 5