HHB comm CDR-882 user manual Parallel Port, Outputs 1 to, Preset, Inputs 1 to, Menu System

Menu System

Parallel Port	rotate the AMS control to display the input (Input 1 to Input 5),
	To assign a different transport commands to one of the inputs,
	press ENTER to select it. The transport function may then be
The Parallel Port submenu permits the user to reprogram
	selected from the list now viewable on the bottom row of the
the pin assignment of the rear panel parallel control port, with
	display by rotating the AMS control. Press the ENTER button
the constraint that the port always provides five inputs and
	again to make the assignment.
three outputs (tallies). The CDR-882 has a factory default pin
assignment, full details of which can be found at page 49. This	The Preset submenu option above must be set to User before
default assignment can be reinstated at any time with the first	any of the Input menu options can be selected.
submenu option, Preset.
There are a total of nine menu options within the Parallel Port	Outputs 1 to 3
submenu, one to select the default (or not), and one for each of
the eight control inputs/tallies.
Preset

	The remaining three submenu options allow the functions of the
	three Parallel Port outputs (pins 7-9) to be reassigned. The
	three options are identical in operation.
	There is a “menu” of six transport tallies (including OFF – i.e. no
This menu option has two settings, Default and User, which
	assignment), from which any three may be programmed onto
may be considered as two memories. Default always contains	the three output pins of the Parallel Port connector. These are
the factory assigned pinout (see page 49), selecting Default	as follows:
assigns this to the Parallel Port connector. If User is selected,
the pinout applied is that which has been set up in the remaining		Function		Default Assignment
submenu options listed below. The factory default contents of
		PLAY	Output 1
the User memory is the same as that of the Default memory.
		PAUSE	Output 2
User must be selected to reassign any (or all) of the inputs and/
		RECORD	Output 3
or outputs.
		NO DISC	Not assigned
Inputs 1 to 5		CHANGE OVER*	Not assigned
		OFF	Not assigned
	* In DiscSpan mode, CHANGE OVER indicates a new disc may
	be inserted.
	To assign a different tally to one of the outputs, rotate the
	AMS control to display the output (Output 1 to Output 3), press
	ENTER to select it. The transport function may then be selected
	from the list now viewable on the bottom row of the display by
	rotating the AMS control. Press the ENTER button again to
	make the assignment.
	The Preset submenu option (above) must be set to User before
The next five submenu options allow the functions of the five
	any of the Output menu options can be selected.
Parallel Port inputs (pins 1-5) to be reassigned. The five options
are identical in operation.

There is a “menu” of nine transport commands (including OFF

–i.e. no assignment), from which any five may be programmed onto the five input pins of the Parallel Port connector. These are as follows:

Function	Default Assignment
PLAY/PAUSE	Input 1
RECORD	Input 2
STOP	Input 3
AMS +	Input 4
AMS -	Input 5
FFWD	Not assigned
FREW	Not assigned
EJECT	Not assigned
OFF	Not assigned

36 www.hhb.co.uk CDR-882 User Manual Version 1.0