3.Scroll to the fixture number you want to set up and press ASSIGN.

If you attempt to assign a fixture that is already assigned, you may adjust the PAN, TILT and AXIS but not the DMX address. To change the DMX address, you must first remove the fixture and then re-assign it with the new address.

•Press SetUp

•Press Fixts •Select from 1-16and pressASSIGN •Select fixture typeand press STORE •Set DMX addressand press STORE

When setting up your fixtures you will need to make certain DIP switch selections on the fixture itself. Often there are two DIP switch- es, one for the personality and one for the DMX start address setting.

The main personality setting will often involve a choice between some other type of protocol and DMX. Always choose DMX when working with the Power Cue DMX. Other available settings will vary according to the model and brand of fixture.

You will need to set a DMX start address for each fixture on the other DIP switches. These addresses must correspond to the addresses you set on the Power Cue DMX. Please refer to the manual for your fixtures for instructions.

Many intelligent fixture instruction manuals also provide a table, showing how to set the DIP switches for any required address.

It is easy to become confused when working with fixtures that are not all the same way up or facing in the

same direction. The Power Cue TIP! DMX helps you here. The PAN and

TILT options in step 5. above allow you to change left to right and right to left, so that you can work on opposite sides of a room simultaneously.

AXIS allows you to switch horizontal and vertical and is useful when working with fixtures installed horizontally instead of vertically.

13