Hitachi 32LD9700N, 32LD9700U, 37LD9700U, 37LD9700C Troubleshooting Symptom and Check List, 57 ~

TROUBLESHOOTING (continued)

Symptom and Check List (continued)

Symptoms		Check list		Page
No picture	Check if the Power Cord is plugged into the socket firmly.			19 ,	20
The Indicating lamp → Off	Check if the Main Power is ON.
	Check if all the cables of the external equipments are connected
No picture	correctly and firmly.
	Check if the power of the external equipments is ON.
The Indicating lamp → Orange				68
	Check if the TV/AV mode has been selected correctly.
It means that the unit is in “Power Save
	Check if the PC is in Power Save mode or not.
mode”.
	Refer to “Power Save mode” and “When following messages appears on
	the screen”.
No picture	Check if the signal cable is connected correctly and firmly.			15 ~ 18
The indicating lamp → Green	Adjust the level of Brightness, Contrast and Back Light lower.
The top of the unit and surface of the	It may happen when you use the unit for long hours. Turn off the Main			73 ,	75
panel heat up.	Power of the unit for a while. Please note that this is not malfunction.
Image cannot be displayed in the correct	Press	button to check if the input signal of the displayed image is		28 ,	73 ,
position.	compatible with the specification of the television.			75
When the VCR is in special playback	It could happen when the VCR is connected to Component output, such
features (Fast Forward or Rewind), the
	as 480i. This is not malfunction.
screen gets dark and cannot see the
	Try Composite output or S-video output and check the picture again.
image at all.
	There are some combinations of input signals that the images are not			57 ~ 59
The images are not displayed on sub	displayed on sub pictures.
pictures in “Multi Picture mode”	Please check the Table of “2-Picture” and “4-picture/2-picture(1080i)” for			76
	details.
	The display size is fixed at “FULL” when the receiving signals are
Screen display size cannot be switched	1080i/60Hz, 1080i/50Hz, 720p/60Hz, or 720p/50Hz.			52 ~ 53
correctly.	Check the signal status by pressing the		button on the remote
	control.
	Check if the cables are connected correctly.
Cannot be displayed the image from	Check the output format of the equipments.			73 ~ 75
HDMI 1 or 2.	(Please refer to “Connecting Procedure” and “Recommended Signal
	List”.)

ENGLISH

71