PREPARATION
Remote Control Batteries Installation
This remote control operates on 2 “AA” batteries.
1. Open the battery compartment cover
Slide open the battery compartment cover on the backside of the remote control in the direction of an arrow.
2.Install the batteries
Install 2 “AA” batteries (included) making
sure the polarities match the indication inside the compartment.
Handling the Remote Control
Use the remote control within about 5m from front of the unit’s
| Within 30 |
Within 30 degrees | degrees |
About 3m | About 3m |
| About 5m |
3. Close the battery compartment cover.
To close the battery compartment cover, slide the cover in the direction of an arrow till it clicks shut.
CAUTION
It could cause corrosion or battery leakage and may result in physical injury and/or property damage including fire.
Never mix used and new batteries in the device.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the remote control properly.
Do not drop or cause impact to the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on a wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.
Caution When Moving the Main Unit
As this product is heavy, whenever it is moved, two people are required to transport it safely.
When transferring the unit, hold the unit by using the handgrips at the backside of the panel. (See the figures below for details.)
32” models:
37” models: Handgrips
Handgrips
12
