BASIC OPERATION
Power On/Off
Now, turn On the main power to the unit. Make sure that the Power Cord is plugged into the wall socket.
Main Power switch (on the bottom surface)
To turn On the power of the unit:
1. Press the Main Power switch on the unit.
The Indicating Lamp will illuminates in Red (Standby mode).
2. Press Sub Power button either on the control panel or on the remote control. | DTT/TV |
The colour of the Indicating Lamp turns into Green, and the image will | Sub Power button |
display on the screen. |
|
To turn Off the power of the unit: | SD MEMORY |
CARD | |
1. Press Sub Power button either on the control panel or on the remote control. | |
| |
The image disappears from the screen and the Indicating Lamp turns into | P |
Red (Standby mode). | P |
| |
2. Press Main Power switch to completely turn Off the power of the unit. | Sub Power button |
OK |
| The Indicating Lamp Status Check | PH35814 | |
|
|
|
|
Indicating Lamp | Power Status | Power Switch Status |
|
Status |
| ||
|
|
| |
Off | Off | Main power → Off |
|
Red | Standby mode | Main power → On |
|
Sub Power button → Off |
| ||
|
|
| |
|
| Standby mode as above |
|
Blinks in Red** | Standby mode | whilst upgrading DTT version and operating |
|
|
| Timer Programming on digital channel. |
|
Green | On | Main power → On |
|
Sub power button → On |
| ||
|
|
| |
Orange | Power Save mode* | Main power → On |
|
Sub Power button → On |
| ||
|
|
| |
|
| Power Save mode as above |
|
Blinks in Orange** | Power Save mode | whilst upgrading DTT version and operating |
|
|
| Timer Programming on digital channel. |
|
*About Power Save mode, see “Power Save Mode” and “When Following Messages Appear on the Screen” on 68 and 70 for details.
**9700 models only
NOTE
If the image does not appear on the screen at all, or have any problem, see TROUBLESHOOTING on 70 ~ 72 . It may help you to solve the problems.
You can turn ON the power only by pressing the Sub Power button during the Standby mode.
Do not switch the power On/Off repeatedly in a short period of time. It could cause malfunction.
To avoid sudden surges of electricity when the power comes back on, turn Off the main power of the unit before you leave if there is a power cut during use of the unit.
20