OPERATING INSTRUCTIONS
Indicating lamp
Main power switch
(32)
(37)
(42)
POWER ON/OFF 
button 
Turning Power On and Off
•To turn the monitor power ON, press the main power switch on the monitor main unit to ON, and then press the SUB POWER button of control panel or the power button on the remote control.
•To turn the monitor power OFF, press the SUB POWER button of control panel or the power button on the remote control, and then press the main power switch on the monitor main unit to OFF.
•During normal use, the main power switch is set in the ON position, and the monitor can then be turned ON/OFF using the SUB POWER button or the power button on the remote control.
Indicating lamp
Indicating | Power status | Operating | |
lamp | |||
|
| ||
|
|
| |
Off | Off | When the main power switch is set to | |
OFF. | |||
|
| ||
|
|
| |
|
| When the main power switch is ON, and | |
| Off | the power button on the remote control | |
Lights red | or the SUB POWER button on the | ||
(standby) | |||
| underside of the front of the frame is | ||
|
| ||
|
| OFF. | |
|
|
| |
|
| When the main power switch is ON, and | |
|
| the power button on the remote control | |
Lights green | On | or the SUB POWER button on the | |
|
| underside of the front of the frame is | |
|
| ON. | |
|
|
| |
|
| When the main power switch is ON, and | |
|
| the power button on the remote control | |
| Off | or the SUB POWER button on the | |
Lights orange | underside of the front of the frame is | ||
(Power Save) | |||
| ON. | ||
|
| ||
|
| However, the state in POWER SAVE | |
|
| mode | |
|
|
|
When the indicating lamp lights in orange or the message “No Sync. Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen, there is something unusual about the status of reception. See “Power Save Mode” or “Symptoms That Seemingly Appear to be Failures.” 
ATTENTION
•Avoid repeatedly turning the monitor on and off at short time intervals. Failures might result from such operation.
•Turn off the main power switch before leaving the monitor out of use for an extended period of time.
•If a power failure occurs while the main unit is running, it would be powered on upon recovery from the failure. Turn off the unit main power switch before leaving the main unit.
ENGLISH
21
