Hobart ML-132055 manual Loading, CAUTION Do not jam angle V-spit into the square hub

LOADING

•Insert pointed end of the angle V-spits into left side of rotor, facing the unit (Fig. 23).

CAUTION: Do not jam angle V-spit into the square hub.

•Insert square end of the angle V-spit in the square hub on the right side of the rotor (Fig. 24).

PL-41700

PL-41701

Fig. 23 Fig. 24

•Ensure round end of the angle V-spit drops down so the square end, on the right side, is properly held in place and fully engaged. Repeat for all angle V-spits (Fig. 25).

NOTE: Stagger loading. Angle V-spits must be loaded on alternate positions of the rotor until all positions are loaded. When cooking a partial batch (less than seven/eight angle V-spits), the angle V-spits must be staggered on the rotor.

•Use the foot pedal to start/stop rotor rotation (Fig. 26). Load every other spit position until all spits are in position (for example, load the first position, skip the second, load the third, skip the forth, etc.).

•Close the door.

PL-41702

Fig. 25

PL-41703

Fig. 26

– 15 –