Honeywell 1200g, 1202g Connecting with Keyboard Wedge, Charge and, Connection:, Keyboard Wedge, Communications Base

2.Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal surface.

3.The scanner beeps.

4.Verify the scanner or base operation by scanning a bar code from the Sample Symbols in the back of this manual.

The unit defaults to a USB PC Keyboard. Refer to page 2-4for other USB terminal settings.

For additional USB programming and technical information, refer to “USB Application Note,” available at www.honey- wellaidc.com.

Connecting with Keyboard Wedge

A scanner or base can be connected between the keyboard and PC as a “keyboard wedge,” where the scanner provides data output that is similar to keyboard entries. The following is an example of a keyboard wedge connection:

1.Turn off power and disconnect the keyboard cable from the back of the terminal/computer.

2.Connect the appropriate interface cable to the scanner and to the terminal/computer.

only if power supply is included

Charge and

Communications BaseKeyboard Wedge

Connection:

3.Make sure the cables are secured in the wireways in the bottom of the base and that the base sits flat on a horizontal surface.

4.Turn the terminal/computer power back on. The scanner beeps.

1 - 2