Honeywell 1200g, 1202g Transmit Records to Host, Batch Mode Transmit Delay, name, name, (250 ms), (500 ms), (1000 ms), :Voyager:BT_NAM, :Voyager:BT_NAM, Transmit Inventory Records

Transmit Records to Host

If you are operating in Inventory Batch Mode (see Inventory Batch Mode on page 3-11),and your scanner is set to Don’t Transmit Records Automatically, you must scan the following bar code to transmit all stored records to the host system.

Transmit Inventory RecordsBatch Mode Transmit Delay

Sometimes when accumulated scans are sent to the host system, the transmission of those scans is too fast for the application to process. To program a transmit delay between accumulated scans, scan one of the following delays. Default = Off.

Note: In most cases, a short (250 ms (milliseconds)) delay is ideal, however, longer delays may be programmed. Contact Technical Support (page 13-1) for additional information.

*Batch Mode Transmit Delay Off (No Delay)Batch Mode Transmit Delay Short(250 ms)Batch Mode Transmit Delay Medium(500 ms)Batch Mode Transmit Delay Long(1000 ms)

Scanner Name

You may assign a name to each scanner you are using for identification purposes. The default name is “Voyager.”

Perform the rename operation using either the bar codes on name. where name is the new name for the scanner. If you base one at a time and repeat the :Voyager:BT_NAMname

page 3-16, or by sending the serial command :Voyager:BT_NAM- wish to change the names of additional scanners, link them to the

. command for each scanner.

To rename scanners with sequential, numeric names, scan the following bar codes. Scan the Reset code after each name

change and wait for the scanner to relink to the base.

0001

3 - 15