Honeywell 1200g, 1202g Sequence Timeout, Partial Sequence, Sequence Match Beeper, Output Sequence Editor, Discard Partial Sequence, Sequence Match Beeper Off

Output Sequence Editor

Enter Sequence

Default Sequence

Sequence Timeout

You may wish to set the maximum time between bar code scans in an output sequence. If that maximum time is not met, the output sequence operation is terminated. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout (from 1-65535 milliseconds) by scanning digits from the Programming Chart, then scanning Save. Default = 5000 msec.

Sequence Timeout

Sequence Match Beeper

By default, the scanner beeps when a sequence match is found. If you want the scanner to remain silent, scan the follow-

ing Sequence Match Beeper Off bar code. Default = Sequence Match Beeper On.

Sequence Match Beeper Off

* Sequence Match Beeper On

Partial Sequence

If an output sequence operation is terminated before all your output sequence criteria are met, the bar code data acquired to that point is a “partial sequence.”

Scan Discard Partial Sequence to discard partial sequences when the output sequence operation is terminated before completion.

Scan Transmit Partial Sequence to transmit partial sequences. (Any fields in the sequence where no data match

occurred will be skipped in the output.) If you have programmed a Sequence Timeout (page 4-16)and the timeout is

reached, the partial sequence is transmitted. Default = Discard Partial Sequence.

Transmit Partial Sequence

4 - 16