Honeywell 1200g, 1202g Object Detection Distance, Object Detection Laser Timeout, Long, Long, Short, Short, * Off, * Long, In-Stand, Out-of-Stand, Out-of-Stand, *Short In-Stand

Object Detection Laser Timeout

You can set a timeout for the length of time the laser remains on and attempting to decode bar codes after an object is detected. Set the length (in milliseconds) for a timeout by scanning the following bar code, then setting the timeout (from 1-

65535 milliseconds) by scanning digits from the Programming Chart, then scanning Save. Default = 5000 ms.

Object Detection LaserTimeout In-Stand

Object Detection Laser

Timeout Out-of-StandObject Detection Distance

When the scanner is in the stand and you are using Object Detection Mode, you can set the distance range for detecting objects. Short sets the scanner to detect objects approximately 5 inches (12.7cm) away from the nose. Long sets it to

detect objects approximately 10 inches (25.4cm) away. Default = Short In-Stand, Long Out-of-Stand.

*Short In-Stand

Long

In-Stand

Short

Out-of-Stand

* Long

Out-of-Stand

Character Activation Mode

You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received, the scanner continues scanning until either the Character Activation Laser Timeout (page 4-12),the deactivation character is received (see Deactivation Character on page 4-13),or a bar code is transmitted. Scan the following On bar code to use character activation, then use Activation Character (following) to select the character you will send from the host to start scanning.

Default = Off.

* Off

4 - 11