Honeywell 1200g, 1202g Auto Reconnect Mode, Changing the Scanner’s Bluetooth PIN Code, Save, Event, Bluetooth PIN, Auto Reconnect On, Auto Reconnect On, Base BT Connection

To relink to the charge base, scan the Base BT Connection bar code.

Non-Base BT ConnectionBase BT ConnectionChanging the Scanner’s Bluetooth PIN Code

Some devices require a PIN code as part of the Bluetooth security features. Your scanner’s default PIN is 0000, which you may need to enter the first time you connect to your non-base Bluetooth device. To change the PIN, scan the following bar code and then scan the appropriate numeric bar codes from the Programming Chart inside the back cover of this manual. (The PIN code must be between 1 and 16 characters.) Scan Save to save your selection. Default = 0000.

Bluetooth PIN

Minimizing Bluetooth/ISM Band Network Activity

The following settings can help you customize the relinking behavior of the cordless system to obtain the best compromise between convenience and low interference.

Note: ISM band refers to the 2.4 to 2.48 GHz frequency band used by wireless networks, cordless phones, and Bluetooth.

Auto Reconnect Mode

Auto Reconnect controls whether or not the scanner automatically begins the relink process when a loss of connection is detected. When the Auto Reconnect On bar code is scanned, the scanner begins the relink process immediately, without

user intervention. Default = Auto Reconnect On.

* Auto Reconnect OnAuto Reconnect Off

The following table shows the results of the Auto Reconnect On and Off settings:

Event	Auto Reconnect On	Auto Reconnect Off
Scanner out of range	Relink occurs automatically. If maximum	The scanner is relinked by pressing
	number of link attempts is unsuccessful,	the button.
	then the scanner must be relinked by
	either pressing the scanner’s button or
	placing the scanner in the base. (See
	"Maximum Link Attempts" on page 3-18.)

3 - 17