Chapter 3 — Configure the Computer

Configure Static WEP Security with Funk Security

Before you set static WEP security with Funk security, you need to enable the radio on your computer and set the date. Intermec recommends that you use WPA2-PSK instead of WEP if possible.

1Start Intermec Settings.

2Select Communications > 802.11 Radio > Funk Security.

3Select a Funk security profile to configure.

4Enter the SSID.

5For Association, select Open.

6For Encryption, select WEP.

7For 8021x, select None.

8Enter an ASCII key or hex key value for each key you want to use (Key 1 through Key 4):

For 64-bit WEP, enter a 5-byte value: 5 ASCII characters or 0x followed by 5 hexadecimal pairs.

For 128-bit WEP, enter a 13-byte value: 13 ASCII characters or 0x followed by 13 hexadecimal pairs.

9Select the Transmit key you want to use to transmit data.

10Tap OK.

Use Open (No Security) Associations with Funk Security

To create an open network, you can set no security with Funk security.

1Start Intermec Settings.

2Select Communications > 802.11 Radio > Funk Security.

3Select the active Funk security profile.

4Enter the SSID.

5For Association, select Open.

6For Encryption, select WEP.

7Tap OK.

Thor CV31 Vehicle-Mount Computer User Manual

45

Page 53
Image 53
Honeywell CV31 Configure Static WEP Security with Funk Security, Use Open No Security Associations with Funk Security