until the temperature is reached. If the temperature is not reached in 60 seconds, the unit goes into ready mode. This setting only applies when the energy saving mode is activated. Note:
The default water temperature drop of setpoint minus 15°F (8°C) was based on test results under the following conditions:
Supply Voltage: 230V
Water Supply Temperature 109°F (43°C)
Rinse Cycle Time: 6 seconds (0.53 gal/rack)
Dwell Time: 5 seconds
Ambient Temperature: 77°F (25°C)
b) Continuous Wash Mode
The continuous wash mode (also used when descaling) allows the wash pump motor to run continuously. In this mode, the wash tank heaters and internal booster tank heaters remain
To enter the continuous wash mode, use the "ON/OFF" button to turn off the unit. Press and hold the up and down buttons and the "MODE" button for 3 seconds and press the "ON/OFF" button. As long as the door switch and wash tank water level sensor are closed, the wash pump motor runs and power is supplied to the detergent feeder terminals. "PC" (preventative cleaning) appears in the display and the lamps are off.
To cancel the continuous wash mode, press the "ON/OFF" button.
c) Consecutive Rinse Mode
The consecutive rinse mode (also used in
To enter the consecutive rinse mode, use the "ON/OFF" button to turn off the unit. With the door switch closed, press and hold the "STANDBY/CLEANING" button for 3 seconds. "SC" (self cleaning) appears in the display and the "RINSE" lamp is on.
After running through 5 consecutive cycles, the buzzer beeps, then the unit turns off.
d) Low Water Temperature Lock Function (Auxiliary Code
To ensure the NSF specified minimum wash water temperature of 150°F and rinse water temperature of 180°F, this unit is provided with a function to lock the washing operation until water in the wash tank reaches 150°F and to extend the washing operation for a maximum of 1 minute until water in the internal booster tank reaches 180°F (factory default: OFF).
To activate this function, set service menu item 19 to “ON” referring to “II.D.7.a) Service Menu Access.” The minimum temperature of 150°F cannot be changed.
e) Alert Function (Auxiliary Code A-1 and Later)
To keep water in the wash tank clean, this unit is provided with functions to beep and flash “Ch” (= Change) in the display when wash water should be changed and to continue this alert until the wash tank is refilled (factory default: OFF).
To activate this function, set service menu items 20, 21, 22 and 23 referring to “II.D.7.a) Service Menu Access.”
1)Set service menu item 20 to ON to activate this function (factory default: OFF).
2)Set service menu item 21 to the desired total operation cycles before alert [number in display x 10 cycles] (factory default: 2 (20 cycles)). Change this setting according to the advice of the relevant health department and customer demands.
24
