B. Error Codes
In the event of operation outside of normal parameters, the control board identifies the issue with an error code. For further service information, see "III.C. Service Flow Charts."
1. Error Code Table
Error | Problem | Operation | Reset |
Code | |||
| Wash Tank Auto Fill Error | Unit stops | Use "ON/OFF" button to turn the unit |
A1 | Water level in wash tank does not reach |
| off and then back on. |
|
| ||
| water level sensor after rinse pump has |
|
|
| run preset number of cycles. |
|
|
| Internal Booster Tank Auto Fill Error | Whole unit | Use "ON/OFF" button to turn the unit |
| In auto fill cycle, internal booster tank | stops | off and then back on. |
A2 |
|
| |
water level float switch does not close |
|
| |
|
|
| |
| within 10 minutes after inlet water valve is |
|
|
| opened. |
|
|
| Wash Tank Water Level Error | Auto fill cycle | After auto fill cycle ends, alarm resets. |
A3 | Water level in wash tank goes below | starts |
|
|
| ||
| water level sensor in "READY" mode or in |
|
|
| "STANDBY." |
|
|
| Internal Booster Tank Water Level Error 1 | Normal | Use "ON/OFF" button to turn the unit |
| (Internal Booster Tank Water Level Float | (internal | off and then back on. |
| Switch Closed) | booster tank |
|
o1 | Both internal booster tank water level float | heaters off) |
|
|
| ||
|
|
| |
| switch and internal booster tank backup |
|
|
| water level float switch have remained |
|
|
| closed for 1 minute. |
|
|
| Internal Booster Tank Water Level Error 2 | Normal | Use "ON/OFF" button to turn the unit |
| (Internal Booster Tank Water Level Float | (internal | off and then back on. |
| Switch Open) | booster tank |
|
o2 | Internal booster tank water level float | heaters off) |
|
|
| ||
|
|
| |
| switch is open and internal booster |
|
|
| tank backup water level float switch has |
|
|
| remained closed for 1 minute. |
|
|
| Wash Tank Thermistor Error (short) | Normal | After replacing failed component, |
H1 |
| (wash tank | alarm resets. |
Thermistor senses abnormal temperature | heaters off) |
| |
|
| ||
| (at or above 231°F (110°C)). |
|
|
| Wash Tank Thermistor Error (open) | Normal | After replacing failed component, |
H2 |
| (wash tank | alarm resets. |
Thermistor senses abnormal temperature | heaters off) |
| |
|
| ||
| (at or below |
|
|
| Internal Booster Tank Thermistor Error | Normal | After replacing failed component, |
| (short) | (internal | alarm resets. |
H3 |
| booster tank |
|
| Thermistor senses abnormal temperature | heaters off) |
|
| (at or above 231°F (110°C)). |
|
|
28
