on. If WT WLS is open, BZ beeps continuously, the "AUTO FILL" lamp goes off and "A1" flashes in the display. For details, see "III.B.3.a) Auto Fill Error (A1)."
Note:
1.If DS opens during the auto fill cycle, the "AUTO FILL" lamp goes off, and RPM de- energizes. When DS closes again, the "AUTO FILL" lamp starts flashing and the unit resumes cycling RPM for the remaining number of times determined by the auto fill cycle setting.
2.BTH is
3.If BT WLF/S fails, BT BUWLF/S assumes control. If BT BUWLF/S remains closed for 1 minute, o1 or o2 error appears in the display. For details, see "III.B. Error Codes."
4."STANDBY/CLEANING" button is inactive during the auto fill cycle.
2. Ready Cycle (Unit Inactive)
"READY" lamp and "RINSE," "STANDARD," or "LONG" lamp on.
WT WLS closed. After a rinse cycle, RPM
WTH energizes when WT water temperature is at the wash temperature setpoint or lower. For details, see "Wash Temperature Setpoint" (service menu item 04) in "II.D.7.b) Service Menu Chart." WTH
Note: To prevent the wash or rinse cycle from starting when the door is closed (if service menu item 11 is set for door start), press the "STANDBY/CLEANING" button. The "READY" lamp goes off and the "STANDBY/CLEANING" lamp comes on. Press the "STANDBY/CLEANING" button again to return to "READY." For details on start initiation, see "Wash/Rinse Cycle Start Initiation" (service menu item 11) in "II.D.7.b) Service Menu Chart."
3. Wash Cycle
The wash cycle can be started by either the door switch or the "STANDBY/CLEANING" button. For details, see "Wash/Rinse Cycle Start Initiation" (service menu item 11) in "II. D.7.b) Service Menu Chart."
Door Switch Start
When the "READY" lamp is on, the unit starts operation in the selected mode when DS closes.
Note: If the "STANDBY/CLEANING" button is pressed when the "READY" lamp is on, the "READY" lamp goes off and the "STANDBY" lamp comes on. When the "STANDBY" lamp is on, the unit will not operate even if DS closes. To cancel standby, press the "STANDBY/CLEANING" button.
9
