"STANDBY/CLEANING" Button Start
When the "READY" lamp is on, the unit starts operation in the selected mode when the "STANDBY/CLEANING" button is pressed.
"STANDARD" or "LONG" lamp flashing (depending on the wash mode selected). WPM energizes and power is supplied to DFT for the length of time set by the wash cycle time setting. For details, see "Wash Cycle Time (Standard Mode) or "Wash Cycle Time (Long Mode)" (service menu item 01 or 02) in "II.D.7.b) Service Menu Chart."
WPM draws water from WT and sends it through the wash spray arms. When the wash cycle time has expired, CB checks BT WLF/S. If BT WLF/S is open, the wash cycle is extended and the lights in the display rotate. If BT WLF/S is closed, the unit enters a
During the wash cycle, WTH energizes when WT water temperature is at the wash temperature setpoint or lower. For details, see "Wash Temperature Setpoint" (service menu item 04) in "II.D.7.b) Service Menu Chart." WTH
BTH
Note: If DS opens during the wash cycle, BZ beeps, the "STANDARD" or "LONG" lamp goes off, the "READY" lamp comes on, WPM
4. Rinse Cycle
The rinse cycle starts automatically after the wash cycle. When the mode is set to "RINSE," the rinse cycle can also be started by either the door switch or the "STANDBY/CLEANING" button. For details, see "Wash/Rinse Cycle Start Initiation" (service menu item 11) in "II. D.7.b) Service Menu Chart."
Door Switch Start
When the "READY" lamp is on, the unit starts operation in the selected mode when DS closes.
Note: If the "STANDBY/CLEANING" button is pressed when the "READY" lamp is on, the "READY" lamp goes off and the "STANDBY" lamp comes on. When the "STANDBY" lamp is on, the unit will not operate even if DS closes. To cancel standby, press the "STANDBY/CLEANING" button.
"STANDBY/CLEANING" Button Start
When the "READY" lamp is on, the unit starts operation in the selected mode when the "STANDBY/CLEANING" button is pressed.
10