2. Bin Control Cleaning
Scale may build up on BC. Scale can cause the actuator paddle and magnet to stick. In this case, BC should be cleaned.
WARNING
CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews are securely in place after the icemaker is serviced. Make sure that none have fallen into the dispenser unit/storage bin.
1)Turn off the power supply.
2)Remove the front panel, then move the control switch to the "OFF" position.
3)Remove the top and right side panels. Remove the control box cover, then clear any ice away from BC.
4)Disconnect BC connector from CB K4 (red) connector, then remove BC from the icemaker.
5)Remove the actuator paddle from the switch mount. See Fig. 1.
6)Wipe down BC with a mixture of 1 part Hoshizaki "Scale Away" and 25 parts warm water. Rinse the parts thoroughly with clean water.
7)Reassemble BC and replace it in its correct position.
Note: If the magnet was removed for cleaning, be sure to replace it in its correct position.
8)Reconnect BC connector to CB K4 (red) connector.
9)Move the control switch to the "ICE" position.
10)Replace the control box cover, right side, top, and front panels in their correct positions.
To Control Board
K4 (red) Connector
Bin Control
Proximity Switch
Actuator Paddle
|
|
| Bin Control |
Bin Control Proximity | Proximity Switch | ||
Switch Closed | Open (bin full, | ||
(calling for ice) | icemaker off or | ||
|
|
| shutting down) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Switch Mount
11) Turn on the power supply to start the
automatic icemaking process. | Actuator Paddle |
| |
| Magnet |
Fig. 1
36
