Hotpoint RGB744GER, RGB745GER installation instructions mEEWEL!HGFMEPaf#6E

Models: RGB744GER RGB745GER

1 45
Download 45 pages 3.42 Kb
Page 37
Image 37
mEEWEL!HGFMEPaf#6E

mEEWEL!HGFMEPaf#6E

I

Anti-Tip

1

Device

1

s

H

‘s

Wallplate I

!

it willbe installed.

5.Check for levelness by placinga spirit level or a cup, partiallyfilledwith water, on one of the oven racks. If using a spirit level,take two readings— with the levelplaced diagonallyfirst in one direction and then the other.

6.Adjust the Ievefinglegs until the range is level. ?. After the range is level,slide the range away horn the wall so that the Anti-T~pdevice can

be installed.

WNING:

~Range must be secured with an approved Anti-Tipdevice.

=Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

QAfter installing the Anti-Tipdevice, verify that it is i~~place by carefuily attempting to tilt the range forward.

~This range has been designed to meet all recognized industry tip standards for all norma~conditions.

QThe use ofthis devicedoes not preclude t~P13i11gOfthe range when not pro~erlyinstalled.

~If the Anti-Tipdevice supplied with the range does not fit this applicatio~l,use the unit~ersalAnti-Tipdevice W~02i$7909.

.-

.,

2.Locate the outside edge ofthe device2%’1 toward the center of the range from the marked edge of the range.

S.-Using the deviceas a template, mark the positionof the hole for the screw.

4.For wood construction, drill a pilothole at an angle of 20 degrees from the horizontal.A nail or awlmay be used if a drill is not available.

Mount the Anti-Tipdevicewith the screw provided.

For cement or concrete construction, you will need a l/41t x 1%1’lag bolt and a 1/21’O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

Install the sleeve anchor into the drilled hole md then installthe lag bolt through the device.The bolts must be properly tightened as recommended for the hardware.

5.Slide the range against the wall, and check for proper installationby grasping the front edges of the rear surface unit openings and carefully attempting to tilt the range forward.

.....--“.---—--

Page 37
Image 37
Hotpoint RGB744GER, RGB745GER installation instructions mEEWEL!HGFMEPaf#6E