Hotpoint RGB745GER, RGB744GER ABoBTH@HaLmTERBAksYouMY M&En, Premmtion, LoaTI@H, ‘> ~1

@See Dimensions and Clearances in this section for all rough-inand spacing dimensions.These dimensionsmust be met for safe use of yotu” range. The locationof the electricaloutlet and pipe opening (see Gas Pipe and Electric Outlet hcations) maybe adjusted to meet spec~lc requirements.

~ The range may be placedwith 011clearance (flush) at the back walland side walls of

the range.

LoaTI@H

Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilationare not obstructed by carpeting or woodwork.

QPhillipsand flat-bladescrewdrivers @Penci]and ruler

~Two pipewrenches (one tor backup)

~1%11open-endor adjustablewrench

~3/1611open-end or socket wrench

~.Nut d~+iver

ABoBTH@HaLmTERBAksYouMY M&En

~Gas line shut-offvalve

~Pipe joint sealant or Unapproved pipe thread tape with Teflon*that resists action of natural and LP gases

~Flexible metal applianceconnector (1/2’1I.D.). A $foot length is recommended for ease of instillation but other lengths are acceptable. Never use an old connector when instalbg a new range.

~Flare union adapter for connectionto gas supply line (3/411or 11211NPTx 1/211I.D.)

PROTECT YOUR FkooR

Yourrange, like many other household items, is hea~ and can settle into soft floor coverings such as cushioned vinylor carpeting. Use care when moving the range on this type of flooring. It is recommended that the followingsimple and inexpensive instructions be followedto protect

~Flare union adapter for connectionto pressure regulator on range (1/211N~ x 1/211I.D.)

*Teflon:Registered trademark of DuPont

,—

PREMMTION

. .--.,,-

=,L1~.-

-F&3;J .-

~*:_:..:%:,;

as)

your floor.

The range should be installed on a sheet of plywood (or similar material) as follows: men the

flooY coverizg enh at ti~efiont of the razge, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering. ~is will allow the range to be moved for cleaning or servicing.

~De~}endingon your range, you’llfind the model

3 and serial numbers on a label on the front frame ] of the range, behind the kick pane], storage

~drawer or broiler drawer.

,.,.,. ,f~ - :, ,,—,-_

QRemove all tape and packaging. Lii up the	-:;7$3$
	_~
~	:>-&$
cooktop (on models with dual burners) and
remove any packing material under it. Be sure to
remove plastic fih that covers some chrome
parts (around oven doors, side trim).

~Take the accessory pack out of the oven.

~Check to be sure that no range parts have come ~ loose during shipping.

-...1 --- ~ - -’=-=-

/-.\ /-f. \

‘> ~1

‘..”.,2,

,,,------

\,

/

\ 5

L .-. .: