![Manual background](/images/new-backgrounds/56521/5652177x1.webp)
—
F | Note: C)nsome models the |
may be in a different location. | |
r3 | |
% | Lever shown closed. |
E it is this regulator:
1.Removecap and forciblysnap out plastic plunger from bottom of cap.
~.Turn plunger over and forciblysnap back in originallocation.Note: Plunger must snap into position;the gas type you are converting to must be visibleon lower side of plunger.
3.Reinsert the assembly into the regulator.
Burner Cap
‘Urn:”::
I
Burner
Orifice
Gas inlet
Le~- ~. | 1 | .. . |
|
1.Removegrates, burner caps and burner heads.
2.Removeburner bases by unscrewing the 3 small screws in each base. M burner stidght out,
DO ~i~~ disconnect the wires from the bt~rner bases unless the cooktop needs to be raised.
3.l~ith 7mm or adjustable wrench, remove the 4 ;31’5ssorifice Sptlcls.
gonverti~~g to.
LP orificespuds are in a smallplasticbag packed with this Use a~d Care book. LP or~~eespuds have a
Natural gas orificespuds have a
5.To prevent leakage, make sure the or~~ce spuds are securely screwed into the gas ir~let tubes. Use a small wrench to hold the inlet tube hex to prevent it froIMtwisting.
6.Put old orifice spuds back in the bag to save for possible fiture conversion.
Note: If an orifice spud is accidently dropped, the cooktop
can be raised bv | :\gl | ||
disengaging - |
|
| |
the 2 front clips | *~p” |
| |
with a large flat | j1 II | ||
‘,. | |||
blade scr=wdtiver. |
|
|
DO NOTattempt to raise the cooktop without removing all 4 burner bases.
i1