EQMi9VE~~flTMSM.L~BBUSMERS(continued)
Ifwires were disconnectedto remove the cooktop,feed wires through the burner holes in the cooktop.Attach to each burner electrode terminal carefully,making sure not to bend the terminal. Then lower cooktopuntil it snaps over the clips.
Electrode
Tall Screw
~~ | / | |
|
|
7.Carefullyinsert burner bases straight down with the tube over the orificespud. Replacethe screws, ~nating sure tie M screw is oppositi tie burner electiode h each bwner base.
1.Liftcooktop.
2.Liftburner assemblies straight up and set aside to gain access to stlrface
burner spuds.
~.With a 5/16” wrench, reinove each of the fo[~r
SilL[dS011the sL~rff~~ebllrner
gas inlet tubes
I
2.Locatethe thermostat adjustment screw at left of thermostat shaft. Turn screw clockwiseuntilthe small pointer is at LP or N, depending on the type of gas you are converting to.
3.Replaceoven control knob.
❑COHVERTTHEOWEHBURHEBoRiFicEs
Owensurn@F
1.Removeoven door, storage drawer or broiler drawer, oven bottom and burner baffle. The lower burner ofi~ce spud is located behind the storage drawer, broiier drawer or kick panel. (On some models, a metal shield must be removed to access theortice.)
2.To convert to w gas,
use a 1/211wrench to turn the lower burner orifice spud clockwise.Tighten th spud only until it is snug. To prevent Ieakage, do not overtighten the spud.
TO COnVertto natird gas, loosen the spud about 2 turns.
~~~i!BwrHsY(on models so equipped)
To Convert to ~ ~as9 use a 1/211wrench to turn the upper burner oltice spud clockwise. Tighten spud only until it is snug with the base. To prevent leakage, do not overtighten spud.
TO eonwert $0 natid gas9 loosen tl]e spud about 2 turns.
