4.A small part of the hard drive sits under one of the battery screw tabs (4). To remove it, slide the hard drive toward the top of the computer (5), and then lift it out of the computer (6).
5.If it is necessary to disassemble the hard drive, perform the following steps:
a.Disconnect the hard drive connector cable (1) from the hard drive.
b.Remove the four Phillips PM3.0×3.0 screws (2) that secure the hard drive bracket to the hard drive.
c.Remove the hard drive bracket (3) from the hard drive.
The hard drive bracket, hard drive connector cable, and screws are available in the Hard Drive Hardware Kit, spare part number
Component replacement procedures 37
