To clean the area around the ink nozzles

1Turn on the HP all-in-one and open the print-carriage access door. The print carriage is on the far right side of the HP all-in-one.

2Wait until the print carriage is idle and silent, and then unplug the power cord from the back of the HP all-in-one.

Note When you unplug the power cord, the date and time are erased. You will need to reset the date and time later, when you plug the power cord back in. For more information, see Set the date and time. Any faxes stored in memory are also erased.

3Lift one of the latches to the open position, and then remove the print cartridge.

Note Do not remove both print cartridges at the same time. Remove and clean each print cartridge one at a time. Do not leave a print cartridge outside the HP all-in-one for more than 30 minutes.

4Place the print cartridge on a piece of paper with the ink nozzles facing up.

5Lightly moisten a clean foam rubber swab with distilled water.

6Clean the face and edges around the ink nozzle area with the swab, as shown below.

1 Nozzle plate (do not clean)

2 Face and edges around the ink nozzle area

Warning Do not clean the nozzle plate.

7Place the print cartridge back into the print carriage slot and close the latch.

8Repeat if necessary for the other print cartridge.

9Gently close the print-carriage access door and plug the power cord into the back of the HP all-in-one.

Change the device settings

You can change the power save time and prompt delay time settings on your HP all-in- one so that it behaves according to your preference. You can also restore the device settings to what they were when you purchased your device. This will erase any new defaults you have set.

Set the power save time

The light bulb in the scanner of your HP all-in-one remains on for a specified period so that the HP all-in-one is immediately ready to respond to your request. When the

one-in-all HP your Maintain

User Guide

167