N o t e

N o t e s

Installing the Switch

Installation Procedures

1If you are using the yl module in either of the 3500yl or 6200yl switches with an X2 transceiver installed, the operating ambient temperature should not exceed 40°C (104°F).

b. Push firmly until the gasket seats against the bulkhead.

Bail

Figure 2-3. Securing a transceiver bail.

When switch power is on, the Link and Activity LEDs will come on for approximately two seconds and then go off. This is confirmation the transceiver is completely seated.

c. If your transceiver has a bail, move the bail up, if not your transceiver is now completely installed. Refer to the HP ProCurve Switch yl Module Installation Guide for more details.

To remove the transceiver:

If your transceiver has a bail, lower the bail until it is approximately horizontal, and then using the bail, pull the transceiver from the slot. If your transceiver does not have a bail, pull the transceiver straight out.

4. Install or Remove mini-GBICs (Optional)

You can install or remove a mini-GBIC from a mini-GBIC slot without having to power off the switch. Use only HP ProCurve mini-GBICs.

■The mini-GBIC slots are shared with the four 10/100/1000Base-T RJ-45 ports. If a mini-GBIC is installed in a slot, the associated RJ-45 port is disabled and cannot be used.

■The mini-GBIC ports operate only at full duplex. Half duplex operation is not supported.

■Ensure the network cable is NOT connected when you install or remove a mini-GBIC.

Switch the Installing

2-7