![](/images/backgrounds/285809/hp-6400cl-users-manual-54995034x1.png)
Installing the Switch
Installing the Switch
Installation Procedures
LEDs
The RPS LEDs are located on the back of the RPS/EPS. These LEDs are duplicated on the front of the device. The following graphic shows an example of the back of the RPS/EPS. There are two green LEDs for each RPS port:
■Device Connected■Power StatusProCurve 600 RPS/EPS
|
| Device Connected LED |
|
| Power Status LED |
|
| (J8168A) |
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
| ! RPS Power: 12V backup to one connected device. |
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Device Connected |
|
|
|
|
|
|
|
|
|
|
| ||||
|
| RPS 1 | R1 | RPS 2 | R2 | RPS 3 | R3 | RPS 4 | R4 | |||||||||
|
| Power Status |
|
|
|
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fault | Device | Power | Message |
| Connected | Status |
|
Off | Off | Off | Nothing Connected |
On or Off | Off | On | Not a valid state - should never happen |
Off | On | Off | Switch is connected, RPS is available but |
|
|
| not required |
Off | On | On | RPS is powering the connected device |
Blinking | Off | Blinking | RPS port is in fault mode |
Off | On | Blinking | Switch is requesting power, RPS can not |
|
|
| provide it |
Blinking | On | Off | Switch is unplugged, but RPS is powering |
|
|
| switch |