![](/images/backgrounds/285809/hp-6400cl-users-manual-54995013x1.png)
Introducing the Switch
Front of the Switch
■Restoring Factory Default Configuration - When pressed with the Reset button in a specific pattern, any configuration changes you may have made through the switch console, the web browser interface, and SNMP management are removed, and the factory default configuration is restored to the switch. For the specific method to restore the factory default configuration, see “Restoring the Factory Default Configuration” on page 9, in chapter 4, “Troubleshooting” of this manual.
| LEDs | |
| Table | |
|
|
|
Switch LEDs | State | Meaning |
|
|
|
Power | On | The switch is receiving power. |
(green) | Off | The switch is NOT receiving power. |
|
|
|
Fault | Off | The normal state; indicates there are no fault conditions on the switch. |
(orange) | Blinking* | A fault has occurred on the switch, one of the switch ports, or the fan. The Status LED |
| ||
|
| for the component with the fault will blink simultaneously. |
| On | On briefly after the switch is powered on or reset, at the beginning of switch self test. |
|
| If this LED is on for a prolonged time, the switch has encountered a fatal hardware |
|
| failure, or has failed its self test. See chapter 4, “Troubleshooting” for more information. |
|
|
|
Port LEDs | Displays port link information and network activity information. | |
(green – over- |
|
|
laid with the |
|
|
port number) |
|
|
|
|
|
(2 green LEDs) | Link | Indicates the port LEDs are displaying link information: |
|
| • if the port LED is on, the port is enabled and receiving a link indication from the |
|
| connected device. |
|
| • if the port LED is off, the port has no active network cable connected, or is not |
|
| receiving link beat or sufficient light. Otherwise, the port may have been disabled |
|
| through the switch console, the web browser interface, or ProCurve Manager. |
|
| • if the port LED is blinking* simultaneously with the Fault LED, the corresponding port |
|
| has failed its self test. |
| Activity | Indicates the port LEDs are displaying network activity information. |
|
|
|
Mdl (Module | On | Expansion module is plugged into expansion slot and operating correctly |
Status, green) |
|
|
| Blinking | Expansion module is plugged into expansion slot but has experienced a fault |
| Off | Expansion module is not plugged into expansion slot |
|
|
|
Switch the Introducing