HP 800 G1 manual

3.Pull the latch next to the lower side of the 2.5-inch hard disc drive cage away from the cage to release it, then slide the cage toward the edge of the chassis and lift it out.

4.If there is a second disc drive in the 2.5-inch cage, disconnect both cables from it.

5.Remove the four mounting screws from each 2.5-inch hard disc drive to be removed. Be sure to keep the screws together with the blue rubber grommets to use to install a replacement drive.

NOTE: The primary drive is the lower position in the drive cage. If only one drive is to be installed, it must occupy this position.

6.Remove the 2.5-inch hard disc drive(s) from the cage.

For instructions on installing a hard disc drive, see Installing a 2.5-inch hard disc drive on page 45.

44 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis