HP 800 manual Reload the sheet that was printed by the Create pattern part

Introduction	Media & Ink	Solutions	Front Panel	Printer	Other	Index
				Options
The Front Panel		Menu Structure	Navigating the Menu System		Message Descriptions
		Front Panel Messages (Continued)
	Message		Explanation and Action

Paper too small Press ENTER to retry Press CANCEL to abort

While loading paper into the printer (roll or sheet), the printer has found that it is either too narrow or too short (only for sheet) to be loaded properly.

Press the Enter key to load larger paper, or the Cancel key to stop the load process.

Paper type not valid		You have requested the printer to align paper but it has detected that
to align printheads		the paper loaded is not the right type to use to align the printheads.
Change paper type to		The paper loaded is not big enough to contain the alignment pattern.
align		Unload the paper (select Unload roll or Unload sheet from the
Press ENTER to continue		Paper menu) and then load paper that is the right type for the
		alignment. See Printhead Alignment.
Pattern not found		The printer is trying to perform a scan of the calibration pattern, but
Reload it again, please		the pattern was not found.
		Reload the sheet that was printed by the Create pattern part of the
		calibration routine.
Possibly a paper jam		There may be paper jammed in the printer. (The printer has
1.	Open window	detected that a motor is blocked and the likely cause is a paper jam;
2.	Switch power off	however, it may be due to some other cause.)
3.	Clear paper path	Follow these steps to check the paper path, as described in Clearing
4.	Switch power on	a Media Jam. When the jammed paper has been cleared, you are
5.	Align printheads	strongly recommended to align the printheads, as they are quite
		likely to have become misaligned as a result of the paper jam.

￿

For more Messages, click on the Next Page button