1Additional Setup Information

3Select File Exit.

4Repeat these steps for each open software program, except Program Manager.

Setting the HP DeskJet Printer as the Default

For Windows 95, 98 or NT 4.0:

1From the taskbar select Start Settings Printers.

2Right-click the HP DeskJet 8xxC Series Printer icon and choose Set As Default.

For Windows 3.1x:

1In the Program Manager, open the Main program group.

2Double-click Control Panel to open it, then double-click Printers.

3Select the HP DeskJet 8xxC Series Printer from the Installed Printers list, and then click Set As Default Printer.

4Click Close and exit the Control Panel.

Communications Test and Two-way Communications (Parallel Cable)

When connected with a parallel printer cable, the printer software tests the communication between the computer and the printer, telling you if you have two-way communication. Two-way communication allows information to pass between the printer and the computer. If you do not have two-way communication, your printer cannot send messages to the computer. However, you can still print.

Installing from Disks to a Directly Connected Computer (Parallel Cable)

Note: If the New Hardware Found box appears during the installation procedure, click the ÒXÓ in the upper-right corner of the box, or click Cancel.

1Insert Disk 1 into the disk drive.

2For Windows 95, 98 and NT 4.0, from the taskbar, select Start Run. For Windows 3.1x, from the Program Manager, select File Run.

Note: If you donÕt know which drive letter is for your floppy disk drive, open Windows Explorer or File Manager and look for the letter next to the disk drive icon.

24

Page 32
Image 32
HP 810C, 830C manual Setting the HP DeskJet Printer as the Default, From the taskbar select Start Settings Printers