HP 830C, 810C manual Install the Printer Software, Before You Begin

1Setting Up Your Printer with a Parallel Printer Cable

Step 6: Install the Printer Software

Before you can use your new HP DeskJet printer, you must install the printer software on every computer from which you will print. Your printer software is located on the CD included with your printer. For your convenience, the printer software is also available on diskettes.

From time to time, Hewlett-Packard provides updated printer software. Go to ÒPrinter SoftwareÓ on page 70 for information on obtaining updated printer software.

Go to the appendix, ÒPrinting from DOS ApplicationsÓ on page 91, for information on installing the DOS printing software and printing from DOS.

Before You Begin

1Make sure the computer is set up, operational, and meets the minimum system requirements as given in ÒChecking Your Computer SettingsÓ on page 82.

2Perform all procedures given earlier in this book. This ensures that the printer is properly set up and ready to print.

3Make sure that the printer is connected to the computer with a parallel printer cable and that no peripheral devices (such as scanners, backup units, and switch boxes) are installed between the printer and the computer.

4Make sure both the printer and the computer are turned on.

5Close any software programs that are open and running on the computer, except the HP DeskJet installer, Windows Explorer, or Program Manager. Go to page 23 for instructions on how to close software programs.

6Install the printer software on the computer. Perform the appropriate following installation procedure for your computerÕs operating system and type of disk drives (either CD-ROM or floppy disk).

If you are installing the printer software from the CD, go to ÒInstalling the Printer Software from the CDÓ on page 10. If you are installing the printer software from floppy disks, go to ÒInstalling from Disks to a Directly Connected Computer (Parallel Cable)Ó on page 24.

9