RJ-11 jack cable

NOTE: The RJ-11 jack cable is included in the Cable Kit, spare part number 641830-001.

Before removing the RJ-11 jack cable, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 57), and then remove the following components:

a.Service cover (see Service cover on page 59)

b.Smart Card reader (see Smart Card reader on page 60)

c.Optical drive (see Optical drive on page 61)

d.Hard drive (see Hard drive on page 65)

e.Modem module (see Modem module on page 74)

f.Keyboard (see Keyboard on page 76)

g.Base enclosure (see Base enclosure on page 80)

Remove the RJ-11 jack cable:

1.Turn the base enclosure right-side up, with the front toward you.

2.Release the RJ-11 jack from the clip (1) built into the base enclosure.

Component replacement procedures

85