Installation & Configuration
Setting SCSI ID Switches
Figure 10. Storage Systems, Rear View1 | - Bus A Upper SCSI Connector | 9 - SCSI ID Switch B1 | |
2 | - Bus A Lower SCSI Connector | 10 | - SCSI ID Switch B2 |
3 | - SCSI ID Switch A1 | 11 | - SCSI ID Switch B3 |
4 | - SCSI ID Switch A2 | 12 | - SCSI ID Switch B4 |
5 | - SCSI ID Switch A3 | 13 | - P1 AC Power Connector |
6 | - SCSI ID Switch A4 | 14 | - P2 AC Power Connector |
7 | - Bus B Upper SCSI Connector | 15 | - SCSI Bus Reset Switch (Factory Set Only) |
8 | - Bus B Lower SCSI Connector |
|
|
CAUTION! Changing default factory settings on the SCSI bus reset switch may cause operating system conflicts for the host. Therefore, the SCSI bus reset switch is covered with a label that states "Factory Set Only".
17
Installation