Troubleshooting & Diagnostics Module Replacement Procedures

DDS Tape Module Replacement Procedure

CAUTION! DDS tape modules cannot be replaced while the host is running. You must shut down the host and power-off the storage system before you replace a tape module.

To replace a DDS tape module:

1.Shut down the host and power-off the storage system.

2.Remove the DDS tape module from the storage system (see Figure 27).

3.Install the new DDS tape module into the storage system (see Figure 9 in Chapter 2).

4.Perform host recovery procedures.

Figure 27. Removing a DDS Tape Module

53

Troubleshooting