Product Information

Product Overview

information regarding the Fibre Channel technology, refer to the Fibre Channel SCSI Multiplexer Service and User Manual, part number A3308-90005.

NOTE! The term hot pluggable refers to modules that can be replaced while the host and storage system are operating, without disrupting their operation. Not all modules are hot pluggable, and some modules require the use of command line utilities before the module is removed, and after the module is replaced. The storage systems do not support installation of additional disk modules or DDS tape modules while the host and storage system are operating.

Fan Modules

The storage system is shipped with two fan modules, which provide redundant cooling. If one fan fails, the remaining fan will provide enough cooling capacity for the storage system. Fan modules are hot pluggable. Failed fan modules should be replaced as soon as possible.

Power Modules

The storage system is shipped with one power module. Two power modules provide redundant power for the storage system. If one power module fails, the storage system continues operating on one power module. If two power modules are used, both share the load. Power modules are hot pluggable.

Disk Modules

The storage system can contain any combination of 1-inch-high and 1.6-inch-high disk modules. A 1-inch disk module occupies one slot in the storage system, and a 1.6-inch disk module occupies two slots. The disk modules are available with either a single-ended (SE) or fast/wide differential (DF) SCSI interface. The disk module is enclosed in a plastic module, so SCSI address (ID) jumpers are not accessible. SCSI ID switches on the rear of the storage system are used to set the disk module SCSI ID.

DDS Tape Module

A 1.6-inch-high, single-ended DDS tape module can also be installed into the storage system. The DDS tape module occupies two slots. The DDS tape module is enclosed in a plastic module, so tape module jumpers and SCSI address (ID) jumpers are not accessible. SCSI ID switches on the rear of the storage system are used to set the DDS tape module SCSI ID.

Base Product Configuration

The storage system base product configuration includes the following:

∙one storage system (A3311A/12A/12AZ)

∙two security keys (deskside only - located inside storage system door)

∙door lock (A3311A only)

∙bumper feet (A3311A only - located inside storage system door)

∙two fan modules

∙one power module and power cord

3

Product Information