Changing Your Workstation’s Hardware Configuration
Installing Storage Devices
Storage Device Cable Routing
When you install your storage device, be aware of the suggested cable routing paths as indicated in the cable routing label that is affixed to the top of the storage tray.
Removing the Storage Tray
Perform the following procedure to remove the storage tray from the system unit:
NOTE:To prevent injury, remove monitor from system unit before removing storage tray.
1Remove the storage tray retaining screw, as shown in Figure 27.
2If installed, remove any locking device from the storage tray security loop on the rear of the system unit.
3Place your fingertips in the groove on the bottom of the storage tray bezel. See Figure 27.
Retaining Screw
Figure 27 | Removing the Storage Tray |
4Slide the storage tray completely out of the system unit.
108