HP C180 manual Installing the Egram Module

Changing Your Workstation’s Hardware Configuration

Installing the EGRAM (Enhanced Graphics RAM) Module (C160/C180)

5Install the standoffs into the EGRAM module, as shown in Figure 44. Push the standoffs into the holes on the module until the clips fully emgage with the board.

6Align the connector on the EGRAM module with the connector on the I/O board, while aligning the standoffs with the holes in the I/O board. See Figure 44.

Figure 44 Installing the EGRAM Module

7Connect the EGRAM module to the I/O board. Push down firmly on the connec- tor area to make sure it is fully seated. Push firmly near the standoffs to make sure that they are fully engaged with the I/O board.

132