HP C6200 manual Wired network setup, What you need for a wired network

(continued)

If you want to:

Change the HP All-in-One from a USB connection to a network connection.

NOTE: Use the instructions in this section if you first installed the HP All-in-One with a USB connection, and you now want to change to an Ethernet network connection.

View or change the network settings.

Find definitions of networking terms.

Find troubleshooting information.

See this section:

“Change the HP All-in-One from a USB connection to a network connection” on page 22

“Manage your network settings” on page 22

“Network glossary” on page 29

“Network troubleshooting” on page 120

Finish setup

Wired network setup

This section describes how to connect the HP All-in-One to a router, switch, or hub using an Ethernet cable and how to install the HP All-in-One software for a network connection. This is known as a wired or Ethernet network.

To set up the HP All-in-One on a wired network, you need to do the following:

First, collect all of the required materials.

Next, connect to a wired network.

Finally, install the software.

See this section:

“What you need for a wired network” on page 19

“Connect the HP All-in-One to the network” on page 20

“Install the software for a network connection” on page 21

What you need for a wired network

Before you connect the HP All-in-One to a network, make sure you have all of the required materials.

Connect to a network 19