HP C6200 Connect the HP All-in-One to the network, To connect the HP All-in-One to the network

Chapter 4

❑A functional Ethernet network that includes a router, switch, or hub with an Ethernet port.

❑CAT-5 Ethernet cable.

Finish setup

Although standard Ethernet cables look similar to standard telephone cables, they are not interchangeable. There is a different number of wires in each one, and each has a different connector. An Ethernet cable connector (also called an RJ-45 connector) is wider and thicker and always has 8 contacts on the end. A phone connector has between 2 and 6 contacts.

❑A desktop computer or laptop with an Ethernet connection.

NOTE: The HP All-in-One supports both 10 Mbps and 100 Mbps Ethernet networks. If you are purchasing, or have purchased, a network interface card (NIC), make sure it can operate at either speed.

Connect the HP All-in-One to the network

To connect the HP All-in-One to the network, use the Ethernet port on the back of the device.

To connect the HP All-in-One to the network

1.Remove the yellow plug from the back of the HP All-in-One.

2.Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.

20 Finish setting up the HP All-in-One