HP Clustered Gateway Device Management Software manual

Chapter 2: mx Commands	61
[--startScript <script>]

When Matrix Server selects the active server for a monitored device, the Start script runs on that server. The script pathname can be up to 512 characters long.

[--startTimeout <seconds>]

The amount of time to wait for the Start script to complete.

[--stopScript <script>]

A script that runs on all other servers configured for the monitor to ensure that the device is not active on those servers. The script pathname can be up to 512 characters long.

[--stopTimeout <seconds>]

The amount of time to wait for the Stop script to complete.

[--eventSeverity considerignore]

Whether Matrix Server takes device monitor events (such as a failure or timeout of a Start or Stop script) into consideration when it makes failover decisions. The default is consider.

[--probetype singlemultiple]

Whether the monitor probe occurs on only one server or on all of the configured servers.

[--activitytype singlealwaysmultiple]

Whether the device monitor can be active on only one server or on all of the configured servers. With single, the monitor is active on only one of the selected servers. Upon server failure, the monitor will fail over to an active server unless all associated service and device monitors are down.

With always, the monitor is active on only one of the selected servers. Upon server failure, the monitor will fail over to an active server even if all associated service and device monitors are down.

With multiple, the monitor is active simultaneously on all selected servers.

[--vhosts<vhost1>,<vhost2>,...]

The virtual hosts associated with the device monitor. These virtual hosts will fail over to another network interface when the monitored device fails. By default, no virtual hosts are associated with the device monitor.

Copyright © 1999-2006 PolyServe, Inc. All rights reserved.