HP Clustered Gateway Device Management Software Parameters parameters, Ordering serialparallel

Chapter 2: mx Commands 60

[--type CUSTOMDISKSHARED_FILESYSTEM] The type of device monitor.

[--probeSeverity nofailoverautorecovernoautorecover]

The failover behavior for the monitor. nofailover prevents failover of virtual hosts when the monitored device fails. autorecover fails over the virtual hosts, and when the device is restored, fails the virtual hosts back to the original network interfaces. noautorecover fails over the virtual hosts but does not fail them back after the device is restored. The default is autorecover.

[--parameters <parameters>]

The available parameters depend on the type of monitor:

•DISK device monitor. The parameter is a partition on the disk. The monitor will attempt to read the first block on this partition to determine whether the disk is operating normally.

•CUSTOM device monitor. The parameter is a probe script. The maximum length of the pathname is 512 characters.

•SHARED_FILESYSTEM device monitor. The first parameter is the volume (for example, psd1p6) containing the filesystem to be monitored. The second parameter is the name of a file that the monitor probe should open and attempt to read to determine the health of the filesystem. The filename should be relative to the mount point of the filesystem. When the filesystem is mounted, the mountpath will be prepended to the filename to determine the complete filename path that should be probed. The second parameter is optional.

[--ordering serialparallel]

Whether Matrix Server enforces a strict ordering sequence when it runs Start or Stop scripts. The default is serial, the strict ordering sequence.

[--recoveryScript <script>]

A script that runs after a monitor probe has failed. The script attempts to restore the device. The script pathname can be up to 512 characters long.

[--recoveryTimeout <seconds>]

The amount of time to wait for the Recovery script to complete.

Copyright © 1999-2006 PolyServe, Inc. All rights reserved.