Removal and Replacement Procedures— Microtower (µT) Chassis

6.8Front USB Device

1.Prepare the computer for disassembly (Section 6.1, “Preparation for Disassembly”).

2.Remove the right access panel (Section 6.2, “Access Panel”).

3.Remove the front bezel (Section 6.3, “Front Bezel”).

4.Disconnect the front USB cable from the system board.

5.Remove the single screw that secures the front USB device to the chassis 1, then slide the USB housing up to release it from the chassis 2.

6.Remove the two screws that secure the USB printed circuit board from the inside of the USB housing and then remove the board.

To install the USB board and the USB housing to the chassis, reverse the removal procedures.

 

6–14

359782-002

Service Reference Guide, dx2000 uT