Troubleshooting Without Diagnostics

Solving Network Problems

These guidelines do not discuss the process of debugging the network cabling.

Solving Network Problems

Problem

Cause

Solution

 

 

 

Wake-on-LAN feature is

Wake-on-LAN is not

Use the Network control

not functioning.

enabled.

application to enable Wake-on-

 

 

LAN.

 

 

 

Network driver does

Network controller is

Run Computer Setup and enable

not detect network

disabled.

network controller.

controller.

 

 

 

 

 

 

Incorrect network driver.

Check the network controller

 

 

documentation for the correct driver

 

 

or obtain the latest driver from the

 

 

manufacturer’s Web site.

Network status link light does not turn on or it never flashes.

✎The network status light should flash when there is network activity.

No active network is

Check cabling and network

detected.

equipment for proper connection.

 

 

Network controller is not

Use the Network control

set up properly.

application to verify that the device

 

is working properly.

 

Network driver is not

Reinstall network drivers.

 

properly loaded.

 

 

 

 

 

System cannot autosense

Disable auto-sensing capabilities

 

the network.

and force the system into the

 

 

correct operating mode.

 

 

 

Diagnostics reports a

The cable is not securely

Ensure that both ends of the data

failure.

connected.

cable are securely connected.

 

 

 

 

The cable is attached to

Ensure that the cable is attached to

 

the incorrect connector.

the correct connector.

 

 

 

 

There is a problem with

Ensure that the cable and device at

 

the cable or a device at

the other end are operating

 

the other end of the cable.

correctly.

 

 

 

 

Network controller

Under the Computer Setup

 

interrupt is shared with

Advanced menu, change the

 

an expansion board.

resource settings for the board.

 

 

 

 

The network controller

Replace the NIC or replace the

 

is defective.

system board if the NIC is

 

 

embedded.

Diagnostics passes, but

Network drivers are

the computer does not

not loaded, or driver

communicate with the

parameters do not match

network.

current configuration.

1.Make sure the network drivers are loaded and that the driver parameters match the configuration of the network controller.

2.Make sure the correct network client and protocol is installed.

 

D–18

359782-002

Service Reference Guide, dx2000 uT