Troubleshooting

Chapter 12

For more information, see:

Load envelopes

Text or graphics are cut off at the edge of the page

Cause: The margins are not set correctly in your software application.

Solution: Make sure the margin settings for the document do not exceed the printable area of the HP All-in-One.

To check your margin settings

1.Preview your print job before sending it to the HP All-in-One.

2.Check the margins.

The HP All-in-One uses the margins you have set in your software application, as long as they are greater than the minimum margins the HP All-in-One supports.

3.Cancel the print job if the margins are not satisfactory, and then adjust the margins in your software application.

Cause: The size of the document you are printing is larger than the paper loaded in the input tray.

Solution: Make sure the layout of the document you are trying to print fits on a paper size supported by the HP All-in-One.

To preview the print layout

1.Load the correct paper size into the input tray.

2.Preview your print job before sending it to the HP All-in-One.

3.Check the graphics in the document to make sure that the current size fits within the printable area of the HP All-in-One.

4.Cancel the print job if the graphics do not fit in the printable area of the page.

TIP: Some software applications allow you to scale the document to fit the paper size currently selected. Additionally, you can scale the size of a document from the print Properties dialog box.

Cause: The paper is loaded incorrectly.

Solution: If the paper is misfeeding, it could cause parts of the document to cut off.

Remove the stack of paper from the input tray, and then reload the paper. Make sure that you slide the paper-width guide inward until it stops at the edge of the paper.

For more information, see:

Load full-size paper

A blank page came out while printing

Cause: If you are printing black text, and a blank page comes out of the HP All-in- One, the black print cartridge might be empty.

106 Troubleshooting